To Next Page

To Previous Page

TIWAY I Network Communication

3-9

S5 UniLink Adapter Installation and Operation

3.5 S5 Interface Port Communications

In automation engineering, data must often be exchanged between

programmable controllers or between a programmable controller and a

central process computer. The data exchange can be implemented using the

communications processor CP 525 with its interpreter RK 512 and the

procedure 3964R. This means that the programmable controllers of the

S5 U family (115U, 135U, 155U) can be hooked up with the S5 UniLink

Adapter through one of these CP modules.

Each S5 UniLink Adapter with an S5 PIM is connected to a CP 525

Communications Processor through the S5 interface port with an RS-232

interface. The S5 Adapter uses the RK 512 protocol with the 3964R transfer

procedure to establish communications with the CP 525 module.

Refer to Chapter 2 for a brief description of the steps necessary to set up the

CP 525 Communications Processor.

For more information, consult the CP 525 Communications Processor

manuals.

Port 3 on the S5 UniLink Adapter assumes communications with the

attached CP 525 module using the 3964R transfer procedure. Sections 3.6

and 3.7 discuss the steps involved in transmitting and receiving using the

3964R procedure.

Overview

S5 Interface

Communications

RK 512 Computer

Link with 3964R

Procedure

Siemens SIMATIC TI505 Installation And Operation

Other manuals for Siemens SIMATIC TI505