5
5.6 Parameters for SIMODRIVE POSMO A
5-229
Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
P0973 / 3CD Actual block number and checkback byte/n-actual
300W 075W
Min Standard Max Unit Data type Effective
– – – Hex V2 RO
For the complete PZD status, the actual block number and the return byte in the PKW channel
are signaled here.
Note:
Available from SW 1.4.
The following applies from SW 2.0:
The actual speed value is returned using these bits in the ”Speed setpoint” operating mode
(P930).
The actual value represents the speed at the gear output.
0980:116 / 3D4 Supported parameters
300W 075W
Min Standard Max Unit Data type Effective
––––I2RO
All of the parameters supported by the device are listed here in an increasing sequence.
P980:0 ––> no significance
P980:1 = 1 (P1)
...
P980:77 = 990 (P990)
0990:116 / 3DE Changes with respect to the factory default
300W 075W
Min Standard Max Unit Data type Effective
––––I2RO
All of the parameters which have been changed over the factory default are listed here in an
increasing sequence.
P990:0 ––> no significance
P990:1 = 4 (e.g. P4)
P990:2 = 990 (P990)
P990:3 = after the end of the list
Note:
For parameters with index, the parameter number is listed if at least 1 parameter of the array
was changed.
P1426 / 592 Tolerance band for actual setpoint value
300W
Min Standard Max Unit Data type Effective
0 100 3800 rpm C4 immed.
075W
Min Standard Max Unit Data type Effective
0 100 3600 rpm C4 immed.
This parameter defines the tolerance band for the actual speed value.
If the actual speed value is within this tolerance band around the specified setpoint, the bit
”Speed within tolerance band” is output (ZSW.8).
Note:
This parameter is visible in SimoCom A only in operating mode ”Speed setpoint” (P930).
Available with software version 2.0 and higher.
5 Description of the Functions
02.9904.0108.06
To Next Page
Loading...
Need help?
General