5
5.6 Parameters for SIMODRIVE POSMO A
5-231
Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Table 5-10 Gearbox–dependent parameters (factory presetting – default), continued
P3 P28P22P16P10P964:7Gearboxes
Gear-
box
code
Maximum
current
Maximum
accel-
eration
Maximum
overcur-
rent
Maximum
velocity
Gearbox
step-
down
ratio
Step-
down
ratio
i
Gearbox
Type
Gear-
box
code
[A][mm/s
2
][A][mm/min]–
Step-
down
ratio
i
Gearbox
Type
300 W motor: Gearbox–dependent parameters (factory default setting)
2051
1)
2067
2)
Without
gearboxes
Smooth
shaft
2075
1)
1 30000 42.0 4000 21.0
(without
keyway)
2076
2)
2052
2068
2053
2069
2054
2070
2055
gearbox
2071
2056
2072
2057
2073
2078
2079
1) Upper value ––> gearbox code for the motor without holding brake
2) Lower value ––> gearbox code for the motor with holding brake
Notice
After another gearbox type has been mounted, the
gearbox–dependent parameters no longer match the gearbox and
must therefore be changed corresponding to Table 5-10.
P964:7 (gearbox code) can only be changed with ”SimoCom A” using
the drive configuration.
5 Description of the Functions
02.9904.0108.04