EasyManuals Logo

Siemens SIMODRIVE POSMO A User Manual

Siemens SIMODRIVE POSMO A
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
vi
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
There is a fixed relationship between the edition of the documentation
and positioning motor software release.
The first edition 02.99 describes the functionality of SW 1.0.
02.00 edition describes the functionality of SW 1.0 to 1.2.
What are the essential new functions for SW 1.2 in comparison to SW
1.0?
Run up mode can be set when the unit is powered up again
(P56)
Stand–alone mode (without bus communication, P100, P101)
Skip block
Program stop via traversing block
Set actual position via traversing block
04.01 edition describes the functionality of SW 1.0 to 1.5.
What are the essential new functions for SW 1.3 in comparison to SW
1.2?
Rotary axis: Signal position with modulo evaluation
Direction of rotation of the motor shaft can be reversed (P3)
Holding controller (P56.2, P57)
Status bit ZSW.15: Modified behavior
Behavior when shutting down supplemented
FB 12 ”PARAMETERIZE_ALL_POSMO_A” (from 05.00)
Reading and writing the parameter set of a drive
What are the essential new functions for SW 1.4 in comparison to SW
1.3?
Worm gear SG 75
Resetting the ”reference point set” status via P98
Checkback signal, status of the input/output terminals 1 and 2
Brake sequence control
Additional diagnostics via P954
Jogging without PROFIBUS and parameterization
Backlash compensation with correction direction
Flying measurement/actual value setting
What are the essential new functions for SW 1.5 in comparison to SW
1.4?
First software for 300 W motors
Shared software for 75 W and 300 W motors
Different union nuts for the connection cover for 75 W and 300 W
motors.
”SimoCom A” parameterizing and start–up tool
PROFIBUS: Initiating a POWER ON–RESET via P97
Edition of the
documentation?
Software release?
What is new?
Foreword
06.05

Table of Contents

Other manuals for Siemens SIMODRIVE POSMO A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMODRIVE POSMO A and is the answer not in the manual?

Siemens SIMODRIVE POSMO A Specifications

General IconGeneral
BrandSiemens
ModelSIMODRIVE POSMO A
CategoryEngine
LanguageEnglish

Related product manuals