Siemens SIMODRIVE POSMO A User Manual

3
3.2 Commissioning the DP master
3-81
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
The following prerequisites must be fulfilled in order to establish online
operation between ”SimoCom A” and a drive via the PROFIBUS–DP
fieldbus:
1. Communication modules, if ”connect via PROFIBUS”
– CP 5511 (PROFIBUS connection via PCMCIA card)
Configuration:
PCMCIA card, type 2 + adapter with 9–pin SUB–D socket
connector to connect to PROFIBUS.
Order No. (MLFB): 6GK1551–1AA00
or
– CP 5611 (PROFIBUS connection through a short PCI card)
Configuration:
Short PCI card with 9–pin SUB–D socket to connect to
PROFIBUS.
Order No. (MLFB): 6GK1561–1AA00
– CP 5613 (PROFIBUS connection via a short PCI card)
Configuration:
Short PCI card with 9–pin SUB–D socket to connect to
PROFIBUS–DP.
Diagnostic LEDs
PROFIBUS controller ASPC2 StepE
Order No. (MLFB): 6GK1561–3AA00
For newer PGs, this communications interface is already included.
2. SIMATIC CPU, if ”connect via MPI interface”
A routing–capable SIMATIC–CPU is required for a coupling via MPI
interface.
3. S7–DOS from V5.0
The software is also installed when installing ”SimoCom A”.
4. Connecting cables
– between CP 5511 or CP 5611 and the PROFIBUS fieldbus
or
– between the MPI interface from the PG and SIMATIC CPU
Note
Going online/offline in cyclic operation via PROFIBUS:
While PROFIBUS is in cyclic operation, ”SimoCom A” with CP xxxx
can be connected or disconnected from the fieldbus using the following
plug–in cable without generating an error.
Order No. (MLFB): 6ES7901–4BD00–0XA0 (plug–in cable)
Prerequisites for
online operation
3 Commissioning
02.9905.03

Siemens SIMODRIVE POSMO A Specifications

General

Brand	Siemens
Model	SIMODRIVE POSMO A
Category	Engine
Language	English