Siemens SIMODRIVE POSMO A

3
3.3 Commissioning an axis
3-91
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
In addition to the preceding formulas the following condition applies for
parameter P2:
P2  P1
This means that a revolution at the gearbox output must be smaller
than or equal to the rotary axis circumference.
Note
If P2 > P1 is selected, the axis zero of the rotary axis cannot be repro-
duced for several revolutions.
3 Commissioning
02.9910.07