Siemens SIMOTION D410-2

Dimension drawings
5.3 CAD data, dimension drawings, and circuit-diagram macros
SIMOTION D410-2
Manual, 02/2012
73
5.3 CAD data, dimension drawings, and circuit-diagram macros
Dimension drawings and CAD data
Dimension drawings, as well as 2D and 3D CAD data can be found:
● In the CAD Creator at the following Internet address
(http://support.automation.siemens.
com/WW/view/en/30559271).
● In the DT Configurator of the Industry Mall (http://www.siemens.com/dt-c
onfigurator).
Circuit-diagram macros
EPLAN circuit-diagram macros are available for the SIMOTION D410-2. The macros are
supported when you create circuit diagrams.
For information on how to do this, refer to: Internet address
(http://support.automation.siemens.
com/WW/view/en/31622426).