Installation
3.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
60 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
I/O terminal diagram - all varaints
The maximum combined current for all digital inputs is 200 mA and the maximum combined
current for all digital outputs is 500 mA.
M12 connector, 5 Pole, female
Specification:
PNP, SIMATIC-compatible,
low <5 V, high > 10 V maxi-
mum, input voltage 30 V.
The Control Module (CM) is
fitted inside the terminal hous-
ing and is connected by ribbon
cable to the CPI.
M12 connector, 8 Pole, female
• X10 for USS, Profibus and
Profinet,
• X15 for AS-i
Note
Adaption of inputs and outputs
Further adaption of the inputs and outputs of the Inverter are possible, please refer to
relevant section in the SINAMICS G110M Operating Instructions for further information.
To Next Page
Loading...
