Siemens SINAMICS G110M - Page 63

Installation
3.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
61
Terminal housing mains supply connections
Type: HAN Q4/2 (Input and
Output), 3 AC 380 V (
-10%)
... 480 V (+10%)
Important:
The pinouts refer to the a
c-
tual connectors on the te
r-
minal housing.
The terminal designation
X1/3 is used because the
mains input an
d output can
be swapped around depen
d-
ing on which side of the
terminal housing the CPI is
mounted.
Internal motor and power connection
The internal motor and power connections on the G110M system are located inside the
Control Unit and motor housing. The connections are shown in the following figure.
Figure 3-11 Control Unit motor and power connections