Siemens SINAMICS S200 - System Overview

SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
A5E52388930A AA, 07/2023
13
4.1 System overview
SINAMICS S200 drive system with 1 AC line connection
* The interfaces X131 and X108 are available on the SINAMICS S200 converter only. For more information about the motor
holding brake connection on the SINAMICS S200 Basic converter, see Section "Connecting the motor holding brake - X108
(Page 19)".
①
Fuse or motor starter protector
⑧
Shield clamp
②
Line filter (optional)
1)
⑨
24 V DC power supply
③
External braking resistor (optional)
1)
⑩
STO plug
④
SIMOTICS S-1FL2 motor
⑪
SD card (optional)
⑤
Motor power cable (with brake conductors)
⑫
Commissioning device
⑥
Encoder cable
⑬
Controller (for example, SIMATIC S7-1500)
⑦
Shield plate
⑭
PROFINET to the next participant
1)
When using the components, make sure that they are connected to the ground correctly.