SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
16 A5E52388930A AA, 07/2023
4.3 MOTION-CONNECT cables
M17/M23 circular connector
Conductors for holding brake
Conductors for power supply
Connecting the cables to the motor
Do not put much stress upon cables or connectors while wiring.
Minimum bending radius (R) for the MOTION-CONNECT cables
– Static: 4 x outer diameter
– Dynamic: 7.5 x outer diameter
For medium and high inertia motors, you can adjust the cable
directions by rotating the connectors.
Before adjusting the cables, switch off the power supply. Otherwise,
the motor contains a hazardous voltage and a risk of electric shock.
To Next Page
Loading...
