Siemens SINAMICS S200 - Mounting; Mounting the Converter; Mounting Conditions; Dimension Drawings and Drill Dimensions

SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
6 A5E52388930A AA, 07/2023
3 Mounting
3.1 Mounting the converter
3.1.1 Mounting conditions
To ensure a reliable, continuous, and trouble-free converter operation, observe the following mounting conditions:
• The converter is designed for installation in a control cabinet.
• The converter is certified for use in environments with degree of pollution 2 without condensation, that is, in
environments where no conductive pollution/dirt occurs. Condensation is not permissible.
• The converter fulfills degree of protection IP20 according to IEC 60529.
• The converter supports vertical mounting only. Mount the converter vertically with the operator panel facing upwards.
• Use a conductive steel sheet no thinner than 2 mm as the mounting plate.
3.1.2 Dimension drawings and drill dimensions
All dimensions are specified in millimeters.
Voltage
Frame size
Width
Height
Depth
Fixing
1 AC/3 AC 200 V
FSA
40 mm
170 mm
135 mm
2 x M4 / 2.5 Nm
FSB
40 mm
170 mm
170 mm
FSC
60 mm
170 mm
195 mm
3 AC 400 V
FSA
50 mm
180 mm
200 mm
2 x M4 / 2.5 Nm
FSB
60 mm
180 mm
200 mm
FSC
70 mm
180 mm
200 mm
FSD
95 mm
260 mm
230 mm
4 x M4 / 2.5 Nm