SINAMICS S200 PROFINET servo drive system with SIMOTICS S-1FL2
24 A5E52388930A AA, 07/2023
5.3 Configuring the fundamental settings
If you call the web server for the first time, proceed as follows to define the fundamental settings:
1. Configure the following basic settings:
– Preferred language of the web server user interface
– Converter date and time, either manually or via NTP
2. Click the "Next" button to open the Security Wizard.
3. Select between the following options:
– Low protection: "Continue with low security settings"
With this selection, access to "User Management and Access Control" is deactivated.
– Complete protection: "Configure security settings"
Siemens recommends this factory setting.
Figure 5-1 Configuring security settings
To Next Page
Loading...
