Safety instructions
SINAMICS V20 Inverter
10 Getting Started, 07/2012, A5E03728127
WARNING
During operation and for a short time after switching off the inverter, the marked surfaces of
the inverter can reach a high temperature. Avoid coming into direct contact with these
surfaces.
CAUTION
This equipment is suitable for use in a power system up to 40,000 symmetrical amperes
(rms), for the maximum rated voltage + 10 % when protected by an appropriate standard
fuse.
Repair
WARNING
Repairs on equipment may only be carried out by Siemens Service, by repair centers
authorized by Siemens or by authorized personnel who are thoroughly acquainted with all
the warnings and operating procedures contained in this manual.
Any defective parts or components must be replaced using parts contained in the relevant
spare parts lists.
Disconnect the power supply before opening the equipment for access.
Dismantling and disposal
CAUTION
The packaging of the inverter is re-usable. Retain the packaging for future use.
Easy-to-release screw and snap connectors allow you to break the unit down into its
component parts. You can recycle these component parts, dispose of them in accordance
with local requirements or return them to the manufacturer.
To Next Page
Loading...
