Commissioning
4.1 The built-in Basic Operator Panel (BOP)
SINAMICS V20 Inverter
Getting Started, 07/2012, A5E03728127
27
Digit-by-digit editing
NOTICE
Digit-by-digit editing of parameter numbers or indexes is only possible in the parameter
menu.
Digit-by-digit editing can be performed on parameter numbers, parameter indexes, or
parameter values. This editing method is best suited when large changes are required to
parameter numbers, indexes, or values. For information about the inverter menu structure,
refer to Section "
Inverter menu structure (Page 25)".
Example 1:
Editing parameter numbers
Example 2:
Editing parameter indices
If a parameter is an array, edit indices
as illustrated below:
Example 3:
Editing parameter values
M
To Next Page
Loading...
