Siemens SINAMICS V20 - Blocks; Usscyclicinterrupt [FB2]

3 Principle of Operation
3.2 Blocks
SINAMICS V20 at S7-1200/1500 via USS
Entry ID: 109480894, V1.0, 09/2018
13
 Siemens AG 2018 All rights reserved
Figure 3-4: Block call diagram for SIMATIC S7-1500
User program System blocks Data blocks
Main
[OB1]
InstUssCyclic
[DB1]
(instance DB of FB UssCyclic)
UssCyclic
[FB1]
USS_Drive_Control
[FB631]
Cyclic interrupt
[OB30]
USS_Port_Scan
[FB630]
InstUssCyclicInterrupt
[DB2]
(instance DB of FB
UssCyclicInterrupt)
UssCyclicInterrupt
[FB2]
instUssDriveControl
USS_DB
The UssCyclic and UssCyclicInterrupt user blocks use optimized block access.
3.2 Blocks
3.2.1 UssCyclicInterrupt [FB2]
Call
All activities relating to processing USS communication for the communication
module with the parameterized hardware ID should be combined in this block.
Figure 3-5: UssCyclicInterrupt user FB
The block name is intended to indicate that the block is called by the cyclic interrupt
OB.