4 Configuration and Project Engineering
SINAMICS V20 at S7-1200/1500 via USS
Entry ID: 109480894, V1.0, 09/2018
Siemens AG 2018 All rights reserved
4 Configuration and Project Engineering
This chapter describes the configuration steps necessary for you to create the
sample project. You will find helpful project engineering support, in particular if your
required configuration differs from the supplied application example in terms of
hardware and component parameterization.
Requirement
Configuration software
The software components are installed on your development system according
to Table 2-3.
SINAMICS V20
The parameterization is performed using the built-in BOP (Basic Operator
Panel). Therefore, on the line side, the drive has already been supplied with
230 or 400V – depending on the version.
SIMATIC S7-1200/1500
In TIA Portal, you have opened a new software project or a project to be
expanded/modified.
Default values
The below parameterization of the SINAMICS V20 assumes that the device is in
the as-supplied state or has been reset to factory default. In this state, there is a
default parameterization that forms the basis for Table 4-1. Parameters that do not
have to be changed for this application example regarding the default values will
not be mentioned in the following sections.
When you add a device, for example a controller, from the hardware catalog to the
project in TIA Portal, an associated default parameterization will be created. This
default parameterization will be used as a basis in Table 4-2. Parameters and
settings that do not have to be changed for this application example regarding the
default values will not be mentioned in the following sections.
Both the procedure for parameterizing the SINAMICS V20 and the one for
configuring the SIMATIC controllers in TIA Portal offer various options. The
following configuration steps represent one possible solution. Steps or
procedures deviating from this approach can also lead to the same goal.
To Next Page
Loading...
