Siemens SINAMICS - A.1.8.2 Messages and Parameters

5. Reactivate the ONLINE mode.
6. Carry out a parameter download ("Target system > Load > Load project to target system")
followed by copy from RAM to ROM.
You have now changed over the converter time format to UTC format.
Application example
In the SIEMENS "Industry Online Support", for a typical application example, you can find
detailed documentation with solution strategies and matching code examples:
Time synchronization example (https://support.industry.siemens.com/cs/de/en/view/
88231134)
A.1.8.2 Messages and parameters
Faults and alarms
Note
You can find the description of faults and alarms in the converter List Manual.
Fault number Message
A01099 UTC synchronization tolerance violated
Overview of important parameters
Note
For a description of the parameters, see the converter List Manual.
Parameter Description
p2048 IF1 PROFIdrive PZD sampling time
p3100 RTC time stamp mode
p3101[0...1] Set UTC time
r3102[0...1] Display UTC time
p3103 UTC synchronization technique
p3104 BI: UTC PING synchronization
r3107[0...3] UTC synchronization time out of tolerance
r3108[0...1] UTC synchronization deviation
p3109 UTC synchronization tolerance
p3116 BI: Suppress automatic acknowledgment
Communication
A.1 Communication
Industrial Security
Configuration Manual, 08/2017, A5E36912609A 221