Configuring know-how protection
Make the settings for the know-how protection on the "Drive unit know-how protection" tab.
1. Click the "Drive unit know-how protection" tab.
Figure 5-8 Load to file system know-how protection
By default, the "Without know-how protection" option is active. If you really want to store
the data without protection (not recommended), you can exit the dialog box with "OK" or
"Cancel" at this point.
2. If you want to store with protection, activate one of the following options with a mouse click:
– "Know-how prot. without copy prot."
Required inputs: "New password" and "Confirm password"
– "Know-how protection with basic copy protection (permanently linked to the memory
card)"
Required inputs: "New password", "Confirm password" and "Memory card specified
serial number"
– "Know-how protection with extended copy protection (permanently linked to the memory
card and CU)"
Required inputs: "New password", "Confirm password" "Memory card specified serial
number" and "Control unit specified serial number"
The input fields for the passwords and the serial numbers appropriate for the activated
know-how protection are then active.
Security measures for SINAMICS
5.2 Write protection and know-how protection
Industrial Security
46 Configuration Manual, 08/2017, A5E36912609A
To Next Page
Loading...
