Siemens SINUMERIK 808D ADVANCED Training Manual

808D ADVANCED Page 35 Programming and Operating — Turning
Create Part
Program
Part 2
s
Unit Description
This unit describes how to create and edit a part program, and get to know
the most important CNC commands required to produce a workpiece.
Part 2
Unit Content
Tapping
Drilling
center
holes
Drilling
holes
Thread
cutting
Contour
turning
cycle
Grooving
Cutting off
Step 1
The easiest way to
perform roughing/
finishing along the
contour is to use
the “contour turn-
ing” cycle function.
By selecting the
“Turn.” SK, you can
enter the cycle and
set parameters.
The “Contour
turning” SK can be
found on the right
vertical menu.
The related
parameters can be
set on the screen.
Contour
turning
cycle
Content
BASIC THEORY
End

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English