Siemens SINUMERIK 810M - Deleting;Modifying an Individual Offset Value

3 Operating Sequences 09.91
3.1.4 Tool offset
3.1.4.2 Deleting/modifying an individual offset value
You select the desired tool offset number under which you intend
to delete/modify a offset value with the ”Page up/down” keys.
With these keys you position the cursor at the input field to be
deleted/modified.
or
Using the numerical keys you enter the value ”zero” (delete)
or
Using the numerical keys you enter a new value (modification).
With this key you transfer the deletion or modification into the
offset memory.
0
a a a a a a a a a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a
a a a a a a a
a
a a a a a a a a a
S
...
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
...
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
a a a a a a a a a
3-10 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)