Siemens SINUMERIK 810M - Lists of Terms Used

09.91 8 Appendix
8.2 Lists of terms used
8.2 Lists of terms used
Term Section
Acknowledge alarm 2.1.1.5
Actual position 2.1.1.5
Actual value setting 2.3.2
Actual value setting (Preset) 3.2.11
ADD.FUNCT. 2.5
Address keys 2.1.1.3
Alarm acknowledge 2.1.1.5
Alarm Messages 4.6
AUTOMATIC 2.3.2
Automatic tool compensation 3.1.4.2
Automatic zero offset 3.1.5.3
AUTOM. TO 2.5
AUTOM. ZO 2.5
AUTOM. ZERO POINT 2.5
Axis synchronization 3.1.8
Basic dimension 3.1.4
BLOCK end 2.5
BLOCK number 2.5
BLOCK search 2.5
Block search 3.2.3.3
Block transfer 3.1.15.4
BTR START 2.5
Buffer batteries 5.2
Channel switchover 2.1.1.5
CIRCLE 2.5
Cleaning 5.3
CLEAR PRE-OFF 2.5
CONTOUR 2.5
Contour 3.1.11
Control keys 2.1.1.5
COPY 2.5
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02 8-3
SINUMERIK 810M, GA3 (BN)