01.93 7 Interfacing to the Machine
7.1 General notes
7 Interfacing to the Machine
7.1 General notes
The operating of the SINUMERIK 810M depends on the setting of the machine data, and the
Options.
In the basic version of the SINUMERIK 810M (Order No.: 6FC3 551-1AC), the standard
machine data are set in the works.
It can be modified when interfacing to the machine and when the control is equipped with
Options!
Sections 7.2 and 7.3 contain tables showing:
•
possible Order Options which influence the operation.
•
all of the standard machine data which can be modified by machine tool manufacturer,
and influence the operation.
The tables have extra columns for entering the configuration of the control as delivered.
7.2 Ordering data - Options
The Order No. for the basic version of the SINUMERIK 810M control is 6FC3 551-1AC
If the control is equipped with options, the Order No. is extended.
It then has the following format:
e.g. 6FC3 551-1AC - Z
B03 + B75 +..
indicates that Order Code(s)
follow(s)
two Order Codes
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
Tick the boxes in the ”Option supplied with control?” column for the following table if
the Order No. 6FC3 551-1AC-Z is followed by the order code listed.
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02 7-1
SINUMERIK 810M, GA3 (BN)
To Next Page
Loading...
