Siemens SINUMERIK 810M - Page 174

3 Operating Sequences 09.91
3.1.14 “SIMULATION”
a) ”PROGRAM CONTROL”
PROGRAM
CONTROL
SIMULA-
TION
Now operate the ”SIMULATION” softkey again,
and then operate the ETC key to extend the
displayed softkey menu.
This brings you back to the softkey menu for
influencing simulation.
When you operate the ”PROGRAM CONTROL”
softkey...
... the relevant CRT display is shown.
You can alter the simulation ”Status”
using a softkey, by selecting the
desired function and setting to
”YES”.
((Bild 810 M/35 einmontieren))
b) ”BLOCK SEARCH”
BLOCK
SEARCH
Using the softkey, select the ”BLOCK SEARCH”
function.
The relevant display is shown on the
CRT.
((Bild 810M/36 einmontieren))
3-76 © Siemens AG 1990 All Rights Reserved 6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)