To Next Page

To Previous Page

Detailed description

2.3 Type -specific output behavior

Basic logic functions: Auxiliary Function Output to PLC (H2)

34 Function Manual, 11/2006, 6FC5397-0BP10-2BA0

2.3 Type-specific output behavior

Function

The output behavior of the auxiliary function relative to a traverse motion programmed in the

part program block can be defined type-specifically in the following machine data:

• MD22200 $MC_AUXFU_M_SYNC_TYPE (output time M functions)

• MD22210 $MC_AUXFU_S_SYNC_TYPE (output time S functions)

• MD22220 $MC_AUXFU_T_SYNC_TYPE (output time T functions)

• MD22230 $MC_AUXFU_H_SYNC_TYPE (output time H functions)

• MD22240 $MC_AUXFU_F_SYNC_TYPE (output time F functions)

• MD22250 $MC_AUXFU_D_SYNC_TYPE (output time D functions)

• MD22252 $MC_AUXFU_DL_SYNC_TYPE (output time DL functions)

Output behavior

The following output behaviors can be parameterized:

MD $MC_AUXFU_xx_SYNC_TYPE = <value>

Value Meaning

0 Output prior to motion

1 Output during motion

2 Output at block end

3 No output to the PLC

4 Output according to the predefined output specification

For a description of the various output behaviors, see Section "Parameter: Output

Behaviors" of the predefined auxiliary functions.

Note

For the output behaviors that can be set for each type of auxiliary function, please refer to

the relevant detailed machine data description.

References:

/AMD/ Exhaustive Description of Machine Data

Siemens Sinumerik 840 sl Function Manual

Other manuals for Siemens Sinumerik 840 sl