Siemens SINUMERIK 840D sl Operating Instructions

Release management - Updating the eP-Satellite server
5.6 ePS Render Services
eP-Satellite server
Operating Instructions, 06/2009
99
5.6 ePS Render Services
Relevant servers eP-Satellite application render server
Note
ePS Render Services only needs to be installed if you are using solution line clients.
Installing ePS Render Services
First stop the IIS web server service, then uninstall the previously installed Render Services
version. Use Add or Remove Programs in the Control Panel to do this. Following this, run file
RenderServer_x.x.x.x.msi and carry out the installation procedure as described below.
Enter the following information during the setup routine:
Query Input
Location %RenderInstPath%
Password Enter %RenderPasswort%
Hosts %WebServerDomain%
Log directory %RenderLogPath%
Figure 5-4 Render Services

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based