Siemens SINUMERIK 840D sl Operating Instructions

Requirements for operation
2.1 Basic configuration: Server systems
eP-Satellite server
16 Operating Instructions, 06/2009
2.1.2 Installing the eP-Satellite external web server
Relevant servers eP-Satellite External Web Server
IIS must be installed on the web servers before the eP-Satellite can be installed.
To do this, add the Windows "Application Server" component. ASP.NET will also need to be
installed in order to carry out basic installation of the application server.
The images below show all the components required:
2.1.3 Installing the eP-Satellite internal web server
Relevant servers Internal eP-Satellite web server
IIS must be installed on the web servers before the eP-Satellite can be installed.
To do this, add the Windows "Application Server" component. ASP.NET will also need to be
installed in order to carry out basic installation of the application server.
The images below show all the components required:

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based