Introduction
Printing history, registered trademarks
0
© Siemens AG All rights reserved. SINUMERIK, Manual, 5-axis machining
4
SINUMERIK® documentation
Printing history, registered trademarks
Brief details of this edition and previous editions are listed below.
The status of each edition is shown by the code in the "Remarks" column.
Status code in the "Remarks" column:
A .... New documentation
B .... Unrevised reprint with new order number
C .... Revised version with new edition status
If substantive changes have been made on a particular page since the last edition, this is indicated
by the new version code in the header on that page.
Registered trademarks
SIMATIC, SIMATIC HMI, SIMATIC NET, SIROTEC, SINUMERIK, SIMODRIVE and SINAMICS are
registered trademarks of Siemens AG. Other names in this publication may be trademarks whose
use by third parties for their own purposes could violate the rights of the owner.
Edition Order No. Remarks
05/2009 6FC5095-0AB10-0BP1 A
More information is available on the Internet at:
http://www.siemens.com/sinumerik
This document was created using a number of layout and
graphic tools.
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility or design, are
reserved.
© Siemens AG 1995 - 2009. All rights reserved.
Other functions not described in this documentation might be
executable in the control. This does not, however, represent
an obligation to supply such functions with a new control or
when servicing.
We have checked that the contents of this document corre-
spond to the hardware and software described. However, dif-
ferences cannot be ruled out and we can assume no liability
for ensuring full consistency. Nevertheless, the information
contained in this document is reviewed regularly and any nec-
essary changes will be included in subsequent editions. Sug-
gestions for improvement are welcome.
Technical data subject to change.
Order No. Siemens-Aktiengesellschaft
0 Introduction