Siemens SIREMOBIL Iso-C 3D - Checking the Positioning

Siemens AG SPR2-230.814.03.02.02 SIREMOBIL Iso-C 3D
11.05 CS SD 24
Adjusting the calibration phantom 31
Page 31 of 52
Medical Solutions
Checking the positioning 0
• Check that the calibration phantom is positioned in the isocenter. To do so, check both
the horizontal and vertical adjustment at least twice.
¹ When the calibration phantom is positioned correctly, the points of the ball pat-
tern will not be visible at the upper and lower image edges.
See illustration below.
Fig. 17: adjustment