Siemens SIRIUS 3RW40 - Reparameterizing the on; RUN Output Contact; Reset Options for Fault Acknowledgement

Functions
5.4 Functions of the RESET buttons
SIRIUS 3RW30 / 3RW40
Manual, 10/2018, NEB535199502000/RS-AB/005
51
5.4.3.2
Reparameterizing the ON / RUN output contact
For information about reparameterizing the output with the RESET / TEST button, refer to
chapter Parameterizing the 3RW40 outputs (Page 123) .
5.4.4
Reset options for fault acknowledgement
Fault
RESET MODE
Manual RESET
Auto RESET
Remote RESET
Line fault (missing line voltage, phase
failure, missing load)
+ — +
I
e
/CLASS setting not permissible
+
—
+
Asymmetry + — +
Self-protection thyristor
+
+
+
Self-protection bypass + + +
Motor protection
+
+
+
Thermistor motor protection
+
+
+
Supply voltage not permissible
Automatic
Automatic
Automatic