Siemens SITRANS F M MAG 6000 - A.10 External input

Menu diagrams
A.11 Sensor characteristics
SITRANS F M MAG 5000/6000
Operating Instructions, 12/2013, A5E02338368-002 81
A.11 Sensor characteristics
1)
Error status (level or number) on an output is updated only at the time the error status changes
(occurs or disappears). If P40 is suppressed after it has been detected (at power up), the
output does not change state. In this case the power must be switched off/on to suppress the
P40 error on the output.
2)
The frequency can be set to 44 Hz in the MAG 6000 SV transmitter only.