Siemens Sitrans F Series User Manual

Operating
7
These Operating Instructions describe the operation via the local display (HMI). The device can
also be operated via various software.
7.1 Operating via the local display
7.1.1 Display views
There are six display views, all fully configurable. Use the and the keys to switch between
the display views.
Multiple types of views are available:
● Display of measured process values, see Reading the process values (Page 74).
● Display for totalizer operation, see Operating the totalizers (Page 76).
● Display for multipoint calibration, see Operating the totalizers (Page 76).
● Display of a list of active alarms, see Handling alarms (Page 77).
● Display of six configurable diagnostic values, see Reading the diagnostic values (Page 79).
7.1.2 Access control
You can view all items in the HMI menu but the parameters are protected against changes
through access level control. To gain access, select one of the following access levels:
SITRANS FST030 (Modbus)
Operating Instructions, 08/2018, A5E37367739-AD 71

Siemens Sitrans F Series Specifications

General

Measurement Principle	Coriolis, Electromagnetic, Ultrasonic
Communication Protocols	HART, PROFIBUS, Foundation Fieldbus, Modbus
Pressure Range	Varies by model (e.g., up to 400 bar for some models)
Power Supply	24 V DC or 110-230 V AC
Protection Class	IP67, IP68
Housing Material	Stainless steel, aluminum
Liner Material	PTFE, PFA, rubber
Electrode Material	Stainless steel, Hastelloy, platinum