Siemens SITRANS F US - SITRANS FUS060; 3.1 Installing SITRANS FUS060; 3.2 Installation

F US Clamp-on Communications Module Installation
SITRANS F US Clamp-on Communications Module
Compact Hardware Installation Instructions, 2/2014, A5E32586525-AD
11
①
Flow Meter
④
Power Connector location
②
I/O Module cover, cover screw,
standoff
⑤
I/O Module
③
Flow Meter Cover Latch
⑥
I/O Module captive mounting screws
Figure 3-1 New Communications Module Installation
4. Remove the four mounting screws and standoffs ⑥ that secure the I/O Module ⑤ and
discard.
5. Install the new standoffs supplied in the mounting kit in the vacant positions.
6. Place the Communications Module over the I/O Module and align connector J3 with P1 of
the I/O Module (figure 3-2).