Siemens SITRANS P series Supplement To Operating Instructions

SITRANS P, DS III PROFIsafe series
Supplement to Operating Instructions, 03/2006, A5E00732533-01
iii
Table of contents
1 PROFIsafe.............................................................................................................................................. 1-1
1.1 Introduction ................................................................................................................................ 1-1
1.2 Technical advantages of PROFIsafe ......................................................................................... 1-1
1.3 Further information..................................................................................................................... 1-2
1.4 Preconditions ............................................................................................................................. 1-2
1.5 PROFIsafe Configuration........................................................................................................... 1-3
1.5.1 Import EDD with SIMATIC PDM ................................................................................................ 1-3
1.5.2 Configure CPU with HW Config................................................................................................. 1-3
1.5.3 Configure device with HW Config .............................................................................................. 1-4
1.5.4 Configure CFC ........................................................................................................................... 1-4
1.6 Extended write protection .......................................................................................................... 1-6
1.6.1 Overview .................................................................................................................................... 1-6
1.6.2 Create user-defined PIN and lock the device ............................................................................ 1-7
1.7 PROFIsafe Commissioning........................................................................................................ 1-7
1.7.1 Activate and parameterize PROFIsafe with SIMATIC PDM...................................................... 1-7
1.7.2 Commission PROFIsafe with SIMATIC PDM ............................................................................ 1-8
1.7.3 Check write protection with SIMATIC PDM ............................................................................. 1-10
1.8 Quit PROFIsafe commissioning............................................................................................... 1-11
1.8.1 Preparations for maintenance and service .............................................................................. 1-11
1.8.2 Deactivate PROFIsafe commissioning in SIMATIC PDM........................................................ 1-11
1.8.3 Deactivate PIN write protection in SIMATIC PDM................................................................... 1-12
Index................................................................................................................................................ Index-1

Siemens SITRANS P series Specifications

General

Communication	HART, PROFIBUS PA, FOUNDATION Fieldbus
Housing Material	Stainless steel, aluminum
Measurement Range	Varies by model (e.g., 0-10 bar, 0-100 bar, etc.)
Output	4-20 mA, HART, PROFIBUS PA, Foundation Fieldbus
Operating Temperature	-40°C to +85°C (-40°F to +185°F)
Ingress Protection	IP66, IP67
Measured Medium	Liquids, gases
Process Temperature	-40°C to +125°C (-40°F to +257°F)
Ambient Temperature	-40°C to +85°C (-40°F to +185°F)
Approvals	ATEX, IECEx, CSA
Process Connection	1/2" NPT