Siemens SITRANS P series - Transportation and Storage; Notes on Warranty

PROFIsafe
1.5 PROFIsafe Configuration
SITRANS P, DS III PROFIsafe series
Supplement to Operating Instructions, 03/2006, A5E00732533-01
1-3
1.5 PROFIsafe Configuration
For safety reasons, the PROFIsafe device is supplied with default settings.
Requirement
Before you commission the PROFIsafe device, configure it in Step7 – for example.
Process
Import EDD with SIMATIC PDM (Page 1-3)
Configure CPU with HW Config (Page 1-3)
Configure device with HW Config (Page 1-4)
Configure CFC (Page 1-4)
1.5.1 Import EDD with SIMATIC PDM
To import the EDD, click on "SIMATIC PDM" > "Manage Device Catalog".
1.5.2 Configure CPU with HW Config
The relevant settings for fail-safe of the CPU are located in the CPU-specific documentation.
Procedure
If your CPU is a SIMATIC CPU, proceed as follows:
1. Double click on the CPU.
2. You are now in the "Properties" dialog box on the "Protection" tab. Activate the following
checkboxes:
– Protection level "1"
– "Removable with password"
– "CPU contains safety program"