Installing
4.4 Alignment of SITRANS SL
SITRANS SL
Operating Instructions, 12/2010, A5E01132948-04
61
Now go to the transmitter
side!
4. Release the clamp ring on
the TTU (transmitter tube
unit) using the wrenches.
Support the transmitter when
releasing.
5. Remove the TTU.
6. Remove the fine aligning unit
from the aiming tool base by
loosening the securing screw
without taking it off. Carefully
slide the fine aligning unit out.
Attach the aiming tool base.
Orient the screw of the
aiming tool towards the
purging inlet such that they
form one line (arrows in
adjacent figure).
7. Start with the coarse aligning
unit. Slide it into the aiming
tool base.
To Next Page
Loading...
