7.3 5-minute quick start with the operator panel and the Ready-for-Use
software
7.3.1 Start
The 5 minutes of quick start is performed in this example with a TP700 Comfort Panel
connected directly to the electronic weighing system. The Panel communicates directly over
MODBUS TCP/IP or via the SIMATIC S7-1200 CPU.
To carry out the quick start, select the "1.0 Setup" function in the main menu and then "1.2 Quick
Start". You will be guided through the individual tasks for setting the most important
parameters.
The remaining parameters are factory-set in such a way that they can be used in most cases
without any changes.
You can download the HMI software used below as free TIA Portal project "Ready-for-use" for
SIWAREX WP321 (https://support.industry.siemens.com/cs/ww/en/view/94109373).
Figure 7-1 Quick start step 1
Commissioning
7.3 5-minute quick start with the operator panel and the Ready-for-Use software
SIWAREX WP321
38 Operating Instructions, 08/2019, A5E33715669A-AD
To Next Page
Loading...
