0.0
0.0
Switching the System On and Off Operation
D.1-2 SOMATOM Spirit
0.0
Switching on the system
D.1
To switch on the system, you have to perform the following
steps:
D.1
✧ Switch on the main switch provided by the customer for
gantry and patient table.
D.1
✧ Activate the I pushbutton at the UPS.
After a short time, the entire system is ready for operation.
D.1
Switching the system on
again
D.1
If you only wish to switch off the system for a few moments or
have switched it off accidentally, do not switch it on again
immediately.
D.1
✧ Wait for approximate 1 minute before switching the system
on again.
Switching on after a power
failure
D.1
✓ A power failure has occurred.
✧ Switch the power switch off.
✧ Wait for approximately 1 minute after power recovery.
✧ Switch the system on again.
i
D.1
A warning signal sounds when the UPS has switched to battery
power during power failure.
D.1
To Next Page
Loading...
