Operation Switching the System On and Off
0.0
04/2012
0.0
D.1-25
0.0
Resetting the system
D.1
✓ A corresponding dialog box is displayed.
✧ Confirm with OK.
The dialog box is closed.
D.1
✧ Call up Setup > Continue.
The system will be reset.
D.1
Restarting the system
D.1
✓ Normal power supply is reactivated
D.1
✧ Restart the system. (→ Page D.1-1 Switching the System
On and Off)
D.1
CAUTION
D.1
The detector heating is switched off as long as the system is dis-
connected from the power supply. When you restart the system,
the detector has not yet reached operating temperature!
D.1
Wrong diagnosis due to image artifacts.
D.1
✧ Calibrate the system as part of the check-up. Repeat calibra-
tion (Setup > Calibration) if ring artifacts occur.
To Next Page
Loading...
