0.0
0.0
Software Related Safety Information Safety
A.4-14 SOMATOM Spirit
0.0
Curved cuts
A.4
If you want to view subareas that cannot be obtained by planar,
i.e. flat images, you can draw in a cut line with any curvature
freehand. You can then display this cut as an image in the out-
put segment. The orientation mark and the cutline are displayed
as orientation aids.
A.4
A.4
A.4
CAUTION
A.4
Using non-planar slice images for diagnostic purposes!
A.4
Wrong diagnosis.
A.4
✧ Be careful when interpreting orientation labels. Keep the
shape of the curved cut and its orientation in the volume in
mind.
To Next Page
Loading...
