Siemens UL 1066 - Page 100

9 – 20
Modifying the angle of the display
At the factory, the alphanumeric display is installed with a downward inclination. However, it can be turned in a vertical direction by 180°, the
display is then inclined upwards.
- OPEN the circuit breaker and discharge the closing spring  (page 23-2)
- Disconnect external 24 V DC voltage supply, if applicable
- Remove trip unit sealing cap, if applicable  (page 9-53)
Removing the display
DANGER
Hazardous voltage.
Will cause death, serious personal injury, or equipment damage.
Turn off and lock out all power supplying this device before working on this device.
5
1
2
3
4