9 – 61
Connecting wires
Circuit diagrams (page 8-1)
(1) Hand plug X8
(2) Connecting cable to first external CublicleBUS module or terminating resistor
(3) Connecting cable to hand plug X8
Connections for additional inputs and outputs
Designation Assignment Terminal
X8-1 c - X8.1
X8-2 c + X8.2
X8-3 24 V DC + X8.3
X8-4 24 V DC GND X8.4
NOTE
If no external cmodules are connected to the COM15 module, the terminating resistor has to be plugged into the
cterminal.
Absence of the terminating resistor can cause errors and potentially loss of communications.
3,0 x 0,6
1/8“
0,5 Nm
4 lb-in
To Next Page
Loading...
