Siemens ULTRAMAT 23 - Hazardous Area Installation

Operation
5-14
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
Ser. No. : XX-XXX Revision : X Order No. : MB23300000000000000
573
Status Diagnostic values Fact. settings hard Fact. settings soft
57
Firmware No.
S79610-G210-A900
Softversion: 2.05.04 from 30.03.00 3.0
574
IR diagnostic values O2 diagnostic values Pressure sens. diagn Other diagn. values
572
Power/IR Source Reference/Bridge Temperature of LCD Analog Output
5724
Pressure ADU: X.XXX V Pressure amb. air:
5723
Sensorsig.:XX.XX mV O2 :XX.XX % Inst.date :XX.XX.XXXX Inst.volt.:XX.XX mV
5722
Logbook/Faults Maintenance request AUTOCAL deviation O2 sensor status
571
Level 1 requiredChoose component Level 1 required
IR Drift readings
XXX AUTOCAL
Deviation : XXX.XX % Max.allowed: XXX.XX %
5713
No maintenance request registered press ENTER to clear next message with ->
5712
O2 Sensor status Reading : xx.xx mV Maint.Req.: 6.00 mV Fault : 5.00 mV
5714
Flow too low during AUTOCAL press ENTER to clear next message with ->
5711
Lockin-ADU + temp. V-ADUt Raw values Not limited concen.
5721
Choose component Raw values NNNNN : XXX.XX % NNNNN : XXX.XX % NNNNN : XXX.XX %
5721c
NNNNN V(T): XXXXXX NNNNN V(T): XXXXXX NNNNN V(T): XXXXXX
T: XX.X°C TS:*****°C
5721b
XXXXX mg/m3 NNNNN M1 XXXXX mg/m3 NNNNN M2 XXXXX mg/m3 NNNNN M3 XX.XX % O2 M4
5721d
Lockin-ADU NNNNN X= XXXXXX Y= XXXXXX R= XXXXXX V= XXXXXX B= XXXXXX T= XX.XC
5721a
NNNNN XX.XX 0 /20mA NNNNN XX.XX 0 /20mA NNNNN XX.XX 0 /20mA NNNNN XX.XX 0 /20mA
5724d
LCD temp. : XX.XX°C
5724c
Reference : X.XXX V Bridge : X.XXX V
5724b
Power (VAC): XXX % Raw voltage:XX.X V Source 1 :XX.XXX V Source 2 :XX.XXX V
5724a
XXXX mbar
Fig. 5-4 Menu sequence for ”Analyzer status”