Siemens ULTRAMAT 23 - Analyzer Status: Factory Settings Hardware; Analyzer Status: Factory Settings Software

Operation
5-19
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
S Analog output
The actual value of the output current in mA; (the dimension is not
shown for space reasons) as well as the start-of-scale value (either
0, 2 or 4 mA) and the full-scale value (20 mA) of the output current
range are displayed for each of the measured components. Refer to
Section 5.10.2 for adjustment of the start-of-scale values.
5.7.3 Analyzer Status: Factory Settings Hardware
Factory settings are parameters which are already set on delivery and
which cannot be modified by the user, such as the Serial No., revision
and Order No. The hardware configuration and release version can be
read here.
5.7.4 Analyzer Status: Factory Settings Software
Factory settings are parameters which are already set on delivery and
which cannot be modified by the user, such as the software/firmware
release version. The software release version can be read here.
NO 3.11 4 /20mA
CO 4.25 4 /20mA
SO
2
4.04 4 /20mA
O
2
17.82 4 /20mA
5724d
Ser. No. IK-001
Revision:
Order No.:
573
Firmware No.:
Software version:
date
574