Operation
5-47
Operating instructions ULTRAMAT 23 gas analyzer
C79000-B5276-C216-03
5.10.3.3 Configuration: Tests: Chopper/IR Source
You can use this function to switch the chopper and IR source off.
!
Warning
Important! Essential!
The analyzer is not ready for measurements if the IR source or
chopper has been switched off! Depending on the switch-off period,
you must therefore provide a suff iciently long warm-up mode (e.g. by
restarting the analyzer).
Notice
This function must only be carried out by qualified servicing engineers.
5.10.3.4 Configuration: Tests: RAM Monitor
Servicing engineers can use this function to view the contents of
certain memory areas.
5.10.4 Configuration: Factory Configuration
These are factory settings made especially for your analyzer. Since
modifications to these parameters may influence the functions of your
analyzer, access to these factory settings is only possible by servicing
engineers using a special access code.
Factory config. !
Please enter special
code: 0000
5104
To Next Page
Loading...
