Siemens WM14N208NL - Avoiding Material Damage

Avoid material damage
M2
avoid material damage
▶ Make sure that the length of the
thread at the connection to the
water tap is at least 10 mm.
Too low or too high water pressure can
hinder the device function.
▶ Make sure that the water pressure
on the water supply system is at
least 100 kPa (1 bar) and a
maximum of 1000 kPa (10 bar).
▶ If the water pressure exceeds the
specified maximum value, a
pressure reducing valve must be
installed between the drinking
water connection and the hose set
of the device.
▶ Do not connect the device to the
mixing tap of a pressureless water
heater or boiler.
Modified or damaged water hoses can
lead to material damage and damage
to the device.
▶ Never kink, pinch, modify or cut
water hoses.
▶ Only use supplied water hoses or
original spare hoses.
▶ Never reuse used water hoses.
Operation with contaminated or too
hot water can cause material damage
and damage to the device.
▶ Only use the device with cold tap
water.
Unsuitable cleaning agents can
damage the surfaces of the device.
▶ Do not use sharp or abrasive
cleaning agents.
▶ Do not use cleaning agents
containing strong alcohol.
▶ Do not use hard scouring or
dishwashing sponges.
▶ Clean the device only with water
and a soft, damp cloth.
Material damage
avoid
Avoid material damage
NB!
Incorrect dosage of
fabric softeners,
detergents, care products and
cleaning agents can affect the
operation of the appliance.
▶ Follow the manufacturer's
dosage recommendations.
Exceeding the maximum load
quantity will affect the operation of
the device.
▶ Maintain and do not exceed the
maximum load for each program.
→
"Programs", page 24
The device is secured for transport
with transport locks. Transport locks
that have not been removed can lead
to material damage and damage to
the device.
▶ Before commissioning, completely
remove and store all transport
securing devices.
▶ Completely install all transport locks
before each transport to avoid
transport damage.
Improper connection of the water
supply hose can lead to material
damage.
▶ Tighten the screw connections on
the water supply hand-tight.
▶ Connect the water supply hose
directly to the water tap without
additional connecting elements,
such as adapters, extensions or
valves.
▶ Install the valve housing of the
water supply hose without contact
with the environment and do not
expose it to external forces.
▶ Make
sure that the inside diameter
of the water tap is at least 17 mm.
11