Siemens WM14N208NL - Before First Use; Starting the Washing Cycle Without Laundry

Before first use
V6
for the first use
Before first
use
5.
Fill leaded powder detergent into
compartment II.
Vb
for the first use
prepare
the device for
use.
6.1 Start the washing cycle
without
laundry
Your
device was thoroughly checked
before leaving the factory. To remove
any residual water, wash without
laundry the first time.
1.
Press the program selectorClean
drumto make.
To avoid
foaming, use only half the
amount recommended by the
detergent manufacturer for light
soiling. Do not use wool or delicate
detergent.
2.Close the door.
3.
Pull out the detergent drawer.
4.Approx. Pour 1 liter of tap water into
compartment
II.
6.
Slide the detergent drawer into the
appliance.
7.
To start the program, press Start
Refillto press.
a
The display shows the remaining
program duration.
aAfter the end of the program it shows
display: "End" .
8.
Start the first washing cycle or press
the program selectorOut to make,
to switch off the device.
→
"The Ministry in Essentials",
Page 29
20