Set up and connect
4.Remove the 4 sleeves.
4.5
Connecting the device
Connect the water supply hose
WARNING
Risk of electric
shock!
The
device contains live parts.
Touching live parts is dangerous.
▶ Do not immerse the electric
Aquastop valve in water.
1.Connect the water supply hose to
the tap (26.4 mm = 3/4").
5.
Place the 4 cover caps.
6.
Slide the 4 cover caps downwards.
2.Open the tap carefully and check
whether the connections are
tight.
Connection
types for water drainage
The information will help you connect this
appliance
to the water drain.
NB!
When draining, the water drain hose is
under pressure and can become loose
from the installed connection position.
▶ Secure the water drain hose against
unintentional loosening.
Remark:
To install the transport locks
for transport in the device, create
these
steps undone in the reverse
Remark:Observe the pump-out
heights.
The maximum pumping height is
100 cm.
the
sequence.
15
To Next Page
Loading...
