Set up and connect
Staging location
Holder
Requirements
1.Pull the hoses out of the holders.
The device with
locking lips
→
Page 28
to confirm.
Floor
with wooden
beams
Place the device
comb on a wa-
ter-resistant
wooden plate (thick
too minimal
30 mm) which
is screwed to the
floor.
2.
Loosen and remove all bolts of the
4 transport locks with an open-end
wrench with a spanner width of
13.
Kitchenette The device
al-
borrow under one
continuous work
place sheet,
that fixed with the
adjacent
cupboard is connected
Pine tree. Required
niche width:
60 cm.
On
a wall No mains connection
cable and no
snakes between
wall and appliance
clamp in place.
3.Remove the mains connection cable from
the
holder.
4.4
Remove transport
protections
The device
is secured for transport
with transport locks on the rear of the
device.
Remark:Keep the bolts of the
transport locks and the accessories
n
→
g
ze for r
so
49
eandla
e
t
v
there
egg
tra
ligin
nsport.
place gene","Tran p rtb
Pa ina
14
To Next Page
Loading...
