Siemens WM14N208NL - Resume Program after Rinse Stop; Taking out Laundry; Switching off the Device; Child Lock

Child lock
3.Remove the laundry.
→
"Taking out laundry",
page 32
K1
after all
4 Child lock
Kb
after all
secure your device against accidental
13.13 Resume program after
rinse
stop
wish
to operate via the controls.
Requirements
¡
The rinse stop is activated.
→
"Keys", page 23
¡The last rinse of the
The set program has ended and the
laundry is in the rinse water.
14.1
Activate child lock
▶ Both keys
press condensation.
3
sec.approx. 3 se-
a
The display shows
to give.
aThe controls are
blocked.
aThe child lock remains even after
switching of the device and activated in
the event of a power failure.
display
1.
The programCentrifugeor set a drain
program.
→
"Programs", page 24
2.OnStart Refillto press.
14.2
Deactivate child lock
13.14 Taking out laundry
Required:
To deactivate the child lock,
the device must be switched on.
1.
Open the door.
2.
Remove the laundry from the
drum.
▶ Press
both buttons for approximately 3
seconds 3 sec..
13.15 Switch
off device
a
goes out in the display .
1.Press the program selectorOut to
make.
2.
Wipe the rubber sleeve dry and
remove foreign objects.
3.
Leave the appliance
door open so that
can dry up.
n detergent drawer
t the residual water
32